Unipulse f395 - Page 150

18.Interface
136
・ Before setting each value, be sure to execute the Channel Number Selection setting
(W01).
・ Receiving of abnormal communications (incorrect data) not mentioned particularly in
the following explanations is ineffective. (No return is made from the F395.)
・ For the "
*
"-marked set values, see the following table.
・ "SP" means space (20H).
・ Channel Number Selection changed by the W01 command is exclusive to RS-232C
communication. The Channel Number Selection of the main body is not changed.
Request
Select CH
01 CH
12 CH
Hold
0None
1 Sample Hold
2 Peak Hold
3Valley Hold
4P-P Hold
5 Period P.
6 Period V.
7 Period P-P.
8Time P.
9Time V.
10 Time P-P.
11 Time Auto P.
12 Time Auto V.
13 Time Auto P-P.
14 Relative Min.
15 Relative Max.
16 Inflection A
17 Inflection B
18 Inflection C
19 Inflection D
20 Pulse Hold
P&V Judg. Rate
0 25%
1 50%
2 75%
3 125%
4 150%
5 200%
6 300%
7 400%