Unipulse f395 - Page 162

18.Interface
148
2. All reading: Rejected waveform
3. Point-by-point reading: Latest sampled waveform
F395
RHN1 :
××±０００
.
０±００００
.
０
SY SX
2:
××±０００
.
０±００００
.
０
SY SX
3:
××±０００
.
０±００００
.
０
SY SX
9:
××±０００
.
０±００００
.
０
SY SX
SUM 1 ~ 4
Terminator
・・・
Host
RHN
＊
Terminator
* Entry of a numerical value from 1 to 4 into * allows
reading of the hold data of the *th rejected waveform.
1: Last rejected waveform ~ 4: 4th last rejected waveform
Y-axis data X-axis data StatusHold type
F395
RHG1 :
××±０００
.
０±００００
.
０
SY SX
Terminator
Host
RHG
＊
Terminator
* Entry of a numerical value from 1 to 9 into * allows
reading of the *th hold data.
Y-axis data X-axis data StatusHold type
If there is no hold data, "-----" is totally displayed except for 1: / 2: / - 9:
and SUM.
Differences between go and return measured values are read out
to the data of X-axis at the hold points in Hysteresis 2 mode.
Also, the result of judging of the differences between go and return
measured values are read out in SX.