2.Name and Function of Each Part
12
5. Control connector
This is a connector to input and output control signals, operation ch settings, etc. The
applicable plug is DDK-manufactured 57-30500 (accessory) or an equivalent.
(See "4-3. Control Connector Connection" P25.)
6. SI/F terminal
This is a serial interface (SI/F) terminal block to connect a UNIPULSE-manufactured
printer, external display, data converter, etc.
(See "4-1-2. SI/F Connection" P23, and "18-1. SI/F 2-wire Serial Interface" P132)
7. Analog input / output terminals
These are terminals for strain gauge type sensor / displacement sensor inputs and voltage
outputs.
(See "4-1-1. Analog Input / Output Connection" P21.)
8. Optional slot
Up to four optional boards can be mounted.
To Next Page
Loading...