9.Method of Starting Measurement
44
Example 2
* If a HI or LO alarm is given at the same time when waveform capturing ends,
the waveform is registered in the rejected waveform area.
Example 3
* The level edge is cleared when the STOP signal is turned on with the START signal
ON. Therefore, waveform capturing will not start until the level edge at "B" is
established. (Waveform capturing starts at "A" if the STOP signal is not turned on.)
＋
START
t
WAIT 2
SAMPLE
OFF
ON
Start of waveform capturing
Waveform
start level
Status display
＋
START
t
A
B
STOP
OFF
ON
OFF
ON
Start of waveform capturing
Waveform
start level
Trigger
To Next Page
Loading...