10.Multi-Hold Mode
63
When Pulse Hold is selected by the operation ch at which sampling starts, the main
screen in graphic display is as follows.
・ High and Low Limit Graphs are displayed according to the pulse position.
・ The results of measurement are displayed from the left in the order of pulse input.
・ When no pulse is input, the result of measurement is displayed as "-----."
・ The analog CH used for measurement depends on the Select Analog
CH setting for the operation ch at which sampling starts. The Select
Analog CH setting for operation ch+1/operation ch+2 is ineffective.
・ For the High/Low Limit Judgment output, the result of judgment of the
latest input pulse is output to " LO1,OK1,HI1", and the results of
judgment of all input pulses are accumulated and output to
" LO2,OK2,HI2".
General of the hold functions
The delay times for the Judgment output and COMPLETE do not
include the delay time in the analog circuit (low-pass filter). Also,
calculations have been made with no digital filter. Since the
Judgment output and COMPLETE output are made with respect to
analog-filter- and digital-filter-processed values, the transfer of
signals becomes slow and the delay of each output increases as
each filter is strengthened.
To Next Page
Loading...