471 ANALOGUE OUTPUT 2 SIGNAL SELECTION * 234567 (2.3.12, 2.3.22, 2.3.6.1, 2.3.4.1)
Connect the AO2 signal to the analogue output of your choice with this parameter. For more
information about the TTF programming method, see Chapter 8.9 "Terminal to function" (TTF)
programming principle.
472 ANALOGUE OUTPUT 2 FUNCTION 234567 (2.3.13, 2.3.23, 2.3.6.2, 2.3.4.2)
472 ANALOGUE OUTPUT 2 FILTER TIME 234567 (2.3.13, 2.3.23, 2.3.6.3, 2.3.4.3)
474 ANALOGUE OUTPUT 2 INVERSION 234567 (2.3.15, 2.3.25, 2.3.6.4, 2.3.4.4)
475 ANALOGUE OUTPUT 2 MINIMUM 234567 (2.3.16, 2.3.26, 2.3.6.5, 2.3.4.5)
476 ANALOGUE OUTPUT 2 SCALING 234567 (2.3.17, 2.3.27, 2.3.6.6, 2.3.4.6)
For more information on these five parameters, see the corresponding parameters for the
analogue output 1 (IDs 307-311).
477 ANALOGUE OUTPUT 2 OFFSET 67 (2.3.6.7, 2.3.4.7)
Add –100.0 to 100.0% to the analogue output.
478 ANALOGUE OUTPUT 3, SIGNAL SELECTION * 67 (2.3.7.1, 2.3.5.1)
See ID464.
479 ANALOGUE OUTPUT 3, FUNCTION 67 (2.3.7.2, 2.3.5.2)
This parameter selects the desired function for the analogue output signal. See ID307.
480 ANALOGUE OUTPUT 3, FILTER TIME 67 (2.3.7.3, 2.3.5.3)
Defines the filtering time of the analogue output signal. Setting this parameter value 0 will
deactivate filtering. See ID308.
481 ANALOGUE OUTPUT 3 INVERSION 67 (2.3.7.4, 2.3.5.4)
Inverts the analogue output signal. See ID309.
482 ANALOGUE OUTPUT 3 MINIMUM 67 (2.3.7.5, 2.3.5.5)
Defines the signal minimum to either 0 mA or 4 mA (living zero). See ID310.
483 ANALOGUE OUTPUT 3 SCALING 67 (2.3.7.6, 2.3.5.6)
Scaling factor for analogue output. Value 200% will double the output. See ID311.
484 ANALOGUE OUTPUT 3 OFFSET 67 (2.3.7.7, 2.3.5.7)
Add –100.0 to 100.0% to the analogue output signal. See ID375.
PARAMETER DESCRIPTIONS VACON · 297
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
8
To Next Page
Loading...
Need help?
General
