Valleylab Force FX-C - Section 7. Replacement Procedures

Replacement Procedures
Force FXTM-e Service Manual
Follow the procedures in this section when you need to replace the parts
listed below:
• Battery for battery-backed RAM
• Control board
• Display board and seven-segment LEOs
• Fan
• Footswitch board
• Front panel
• Front panel components, including the REM module and power switch
• Fuses, including two in the fuse drawer and one on the Power Supply/
RF board
• Heat sinks (left front, left rear, and right heat sinks) and associated
heat sink components
• Low voltage power supply
• Power entry module
• Power Supply/RF board.
For your reference, this section also includes an electrical cable
interconnect diagram that illustrates all cable connections.
The parts used in these procedures are illustrated in Section 9.
7 -1