Valleylab Force FX-C - Enter the Commands

Using the RS-232 Serial Port
When activation ceases, the following message is displayed:
key request removed
Step 2 - Enter the Commands
You can enter commands to change settings or display data about the
generator. Each command should begin with a colon (:) and end with
Enter. TIle # symbol represents a numeric value that you enter with
specific commands as noted.
Data Displays
Some commands result in the display of data for each mode, including
CEM. The display format is as follows:
Bipolar Precise Bipolar Standard Bipolar Macro Default
Fulgurate
Cut Low Cut Pure Cut Blend CutCEM
Coag Desiccate LCF Fulgurate
Coag Spray CoagCEM
In data displays, numbers represent the Force FX-C modes. You also use
these numbers when you enter commands to select a specific mode.
Bipolar Modes
o Precise
1 Standard
2 Macro
Gut Modes
o Low
1 Pure
2 Blend
Goag Modes
o Desiccate
1 Fulgurate
2 Spray
Force FXTM-C Service Manual 5-41