Valleylab Force FX-C - Page 120

Using the RS-232 Serial Port
5-42
Commands for Selecting Modes and Power Settings
Command
:FBM#
:FBP#
:FBU
:FBD
:FTM#
Action
Specify the bipolar mode (for #, enter the number for the desired
mode):
0= Precise
1 = Standard
2 = Macro
Specify the bipolar power setting (# = 1, 2, 3, ... 65, 70).
Increment the bipolar power setting to the next higher value.
Decrement the bipolar power setting to the next lower value.
Specify the cut mode (for #, enter the number for the desired mode):
0= Low
1 = Pure
2 Blend
:FTP# Specify the cut power setting(# 1,2,3, ... 290,300).
:FTU Increment the cut power setting to the next higher value.
:FTD Decrement the cut power setting to the next lower value.
:FGM# Specify the coag mode (for #, enter the number for the desired
mode):
o = Desiccate
1 = Fulgurate
2 = Spray
Force FXTM-C Service Manual