Valleylab Force FX-C - Setting up the Generator

Setting Up the Generator
Setting Up the Generator
5-2
Warning
r~¢~~~~~~;9~?~r~t?t;J)p~~r~~rdtQ~pr~p~riri ',;. "
$~PP~~PlI.{\l.~"IiIR~~~;.: l .;; ii ;c
1. Verify the generator is off by pressing the power switch off (0).
2. Place the generator on a stable flat surface, such as a table, platform, or
Valleylab cart. Carts with conductive wheels are recommended. For
details, refer
to the procedures for your institution or to local codes.
Provide
at least four to six inches of space from the sides and top of the
generator for cooling. Normally, the top, sides, and rear panel are
warm when the generator is used continuously for extended periods
of time.
Ensure that the generator rests securely on the cart or platform. The
underside of the generator contains four rubber feet and additional
holes that allow you to reposition the feet to ensure stability. Use a
Phillips
screwdriver to remove the rubber feet from the generator.
Then, reinstall
the feet in the preferred location.
3. According to the procedures used by your institution, connect an
equipotential grounding cable to the grounding lug on the rear panel
of the generator. Then, connect the cable to earth ground.
4. Plug the generator power cord into the rear panel receptacle.
5. Plug the generator power cord into a grounded receptacle.
6. Turn on the generator by pressing the power switch on (I ). Verify the
following:
• All visual indicators and displays on the front panel illuminate.
• Activation tones sound to verify that the speaker is working
properly.
Force fXTM-C Service Manual