Valleylab Force FX-C - Front Panel REM Module Replacement

Front Panel REM Module Replacement
Front Panel REM Module Replacement
Force FXTM-C Service Manual
1. Remove the front panel assembly (observe all warnings and cautions).
Refer to Front Panel Replacement earlier in this section.
2. Remove the two screws that secure the REM module to the front panel
and remove the bracket that covers the REM module. Set the bracket
and screws aside for reinstallation.
3. Replace the existing module with a new REM module.
4. Position the bracket over the new REM module and install the two
screws that secure the module to the front panel.
5. Reinstall the front panel assembly, Refer to Front Panel Replacement
earlier in this se('tion,
7 -11