VIDEOJET 8520 - Job Faults; Purging Faults

8-8 Job Faults Rev AB
Videojet 8520 Operator Manual
Job Faults
Purging Faults
Fault Cause Solution
The job cannot
be opened.
The job is not compatible with
this Firmware version.
The job must be newly created for this
Firmware version.
After a certain
number of prints
the Videojet
8520
automatically
switches to
OFFLINE.
A counter field is printed in
which the counter end value is
predefined and the Videojet
8520 switches to OFFLINE
mode when this value is
reached.
Change the specifications for the job.
A limited print run has been
specified in the job settings.
Change the specifications for the job.
Table 8-2: Job Faults
Fault Cause Solution
No purge
operation
The purge pause setting may be
too long, i.e. the actual print
pause is not as long as the print
pause set in the purge menu.
Adjust the purge setting.
Table 8-3: Purging Faults