Rev AA How to Start the Printer 5-13
Videojet 8520 Operator Manual
How to Monitor the System
The CLARiTY operating system has a screensaver function (similar to that
of a PC), to extend the service life of the backlight tube of the LCD display
used in CLARiTY.
Automatic switching-off of backlight
The screensaver function can be activated or deactivated within CLARiTY
Configuration Manger.
The shut-off time of the screensaver can be adjusted from 5 to 30 minutes.
Actuation of any key causes the screensaver of the controller to be switched
on without triggering any other function on the user interface.
The screensaver is also switched ON again whenever information, a
warning or an error message appear.
If passwords have been assigned an input mask appears upon activation
of the display to query the password for the screensaver.
If a user was logged on before the screensaver came ON, then on
reactivation, the user will be asked to re-verify password.
The default shut-off time has been set to 15 minutes.
PERSONAL INJURY. When the printer is in production and there
has been no activity on the CLARiTY touchscreen for a certain
period of time, the screensaver function is activated. This indicates
that CLARiTY is in power save mode. This option saves energy and
can be configured with CLARiTY configuration manager (Refer to
Service Manual for more information). During such instances, do not
assume that the printer is switched off and approach the printheads.
Always touch the touchscreen to check and confirm printer activity.
To Next Page
Loading...
