virtual access GW1000M Series - Page 291

31: Configuring Terminal Server
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 291 of 350
Figure 148: The general tab fields
Web Field/UCI/Package Option
Description
Web: Enable
UCI: tservd.@port[0].enable
Opt: enable
Enables Terminal Server port.
0
Disabled.
1
Enabled.
Web: Network Forwarding Buffer Size
UCI: tservd.@port[0]. fwd_buffer_size
Opt: fwd_buffer_size
Forwarding buffer size in bytes (serial to network).
256
256 bytes
Range
0-2048
Web: Network Forwarding Timeout(ms)
UCI: tservd.@port[0]. fwd_timeout
Opt: fwd_timeout
Forwarding timeout in milliseconds (serial to network).
30
30 ms
Range
0-10000
Web: Network Forwarding Timer Mode
UCI: tservd.@port[0]. fwd_timer_mode
Opt: fwd_timer_mode
Forwarding timer mode (serial to network).
Idle
Timer is re-started on each received data.
Aging
Timer started on the first Rx.
Web: Serial Forwarding Buffer Size
UCI: tservd.@port[0]. sfwd_buffer_size
Opt: sfwd_buffer_size
Forwarding buffer size in bytes (network to serial).
Set to 0 to use maximum possible network Rx buffer size.
0
2048 bytes
Range
0-2048
Web: Serial Forwarding Timeout (ms)
UCI: tservd.@port[0]. sfwd_timeout
Opt: sfwd_timeout
Forwarding timeout in milliseconds (network to serial).
Set to 0 to forward to serial immediately.
20
20 ms
Range
0-10000