EasyManuals Logo

Wacker Neuson 803 Service Manual

Wacker Neuson 803
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
3-52 SHB 803 en – Edition 2.4 * 803s314.fm
Maintenance
Instructions concerning specific components
Cables, bulbs and fuses
Always observe the following instructions:
Malfunctioning components of the electrical system must always be replaced by a
Wacker Neuson service center. Lamps and fuses may be replaced by unqualified
persons
When performing maintenance on the electrical system, pay particular attention to
ensuring good contact in leads and fuses
Blown fuses indicate overloading or short circuits. The electrical system must therefore
be checked before installing the new fuse
Only use fuses with the specified load capacity (amperage)
–see“Fuse box at the right under the control stand behind the side trim” on page 2-5
Notice!
Always disconnect and remove the battery before performing welding work on the
machine, and short-circuit the terminal cables of the machine to avoid damage to
the electronic components.
Alternator
Observe the following instructions:
Start the engine only if the battery is connected
When connecting the battery, ensure that the poles (+/) are not inverted
Always disconnect the battery before performing welding work or connecting a quick
battery charger!
Replace malfunctioning charge indicator lights immediately
–see“Alternator charge function indicator light (red)” on page 1-12
Fig. 55: Alternator

Table of Contents

Other manuals for Wacker Neuson 803

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson 803 and is the answer not in the manual?

Wacker Neuson 803 Specifications

General IconGeneral
BrandWacker Neuson
Model803
CategoryExcavators
LanguageEnglish

Related product manuals