Wacker Neuson 803 - Checking the Coolant Level;Adding Coolant

SHB 803 en – Edition 2.4 * 803s312.fm 3-23
Maintenance
Checking the coolant level/adding coolant
Danger!
Never open the coolant reservoir and never drain coolant
if the engine is warm since the cooling system is under high pressure.
Burn hazard!
☞Wait at least 15 minutes after stopping the engine!
☞Wear protective gloves and clothing
☞Open filler cap B to the first notch and release the pressure
☞Ensure that the coolant temperature is sufficiently low so you can touch the
radiator plug with your hands
Danger!
Coolant is flammable and poisonous.
Accident hazard!
☞Keep away from flames
☞Avoid eye contact with coolant
• If coolant comes into contact with the eyes
➥Immediately rinse with clean water and seek medical assistance
Notice!
Do not add a different coolant to the one in the reservoir.
• Only use the coolant prescribed by Wacker Neuson
– see Fluids and lubricants on page 3-2.
Checking the coolant level
☞Park the machine on level ground
☞Stop the engine!
☞Raise the control lever base
☞Remove the key and carry it with you
☞Let the engine and the coolant cool down
☞Open the engine cover
☞Check the coolant level on the transparent coolant reservoir 13/A and on radiator 12/B
☞If the coolant level is below the lower mark or if there is no coolant at the radiator’s
filler inlet:
➥Add coolant
☞Close and lock the engine cover
Fig. 12: Radiator cap
B
A
max.
min.
Fig. 13: Coolant reservoir