3-24 SHB 803 en – Edition 2.4 * 803s312.fm
Maintenance
Check the coolant level once a day.
We recommend checking it before starting the engine.
Adding coolant
After the engine has cooled down:
☞Release overpressure in the radiator
☞Carefully open the cap to the first notch and fully release the pressure
☞Open filler cap 14/B
☞Add coolant up to the lower edge of the filler inlet (radiator)
☞Close filler cap 14/B
☞Fill up the coolant reservoir
☞Start the engine and let it warm up for about 5 – 10 minutes.
☞Stop the engine
☞Remove the key and carry it with you
☞Let the engine cool down
☞Check the coolant level again
➥The coolant level must be above the sheet-metal bracket of the coolant reservoir
☞If necessary, add coolant and repeat the procedure until the coolant level remains constant
☞Close and lock the engine cover
Do not add a different coolant to the one in the reservoir.
☞Only use the coolant recommended by Wacker Neuson
– see chapter 2.9 Coolant compound table on page 2-8.
Check the coolant every year before the cold season sets in!
To Next Page
Loading...
Need help?
General
