Design
TITANUS
PRO·SENS
®
100
06/13
ning scale, the allowed total length of pipe can be 120 m for the complete
pipe project planning. The result for the maximum length of the complete air
sampling hose of type SCH-P25, which can be integrated within the pipe
project planning, after formula adjustment is:
Length of the air sampling hose = (Total pipe length - Air sampling pipe length) /
Factor b
Length of the air sampling hose = (120 - 100 m) / 0,3 = 66,67 m
NOTICE
The complete air sampling pipe must not consist of a single air sampling
hose.
NOTICE
Aspiration reduction must not put about the air sampling hose.
Project planning with air return
In some cases, in which differences of air pressure between the area of air
sampling device and the area of air sampling point exist, a channel of air
pressure of the aspirated test air in the pressure area of air sampling points
can be necessary. Therefore, an air sampling hose with a right length should
be connected on the air outlet of the air sampling device.
As the transport time of an air sampling smoke detection device can be ma-
nipulated negatively by an air return, the influence of the air return to the al-
lowed total length of pipe is to be respected.
An air return with a pipe with Ø 40 mm has no influence and can be pro-
jected and/or retrofitted without reducing the total pipe length and / or retrofit-
ted.
5.3.8
To Next Page
Loading...
