TITANUS
PRO·SENS
®
Installation
06/13
121
Electrical connection
In order to prepare the electrical connections follow the steps below:
1. Break through the required cable entries e.g. by means of a screw-
driver.
2. Attach the plastic connection pieces M 20 or M 25 to the cable entries.
3. Pass the cables through the corresponding cable entries.
NOTICE
One plastic connection piece M 20 and 2 x M 25 is supplied with the de-
vice.
The electrical connection is effected via the terminal blocks X6 and X7 on
the main board of TITANUS
PRO·SENS
®
. Pay attention to the allowed wire
cross sections of the corresponding screw joint and to the allowed wire cross
sections of the terminals for max. 1.5 mm² - cores.
WARNING
Connection works are only allowed if the device is powered down!
NOTICE
In order to maximise the fault safety, use shielded cables for the external
wiring of the device(s).
6.6
To Next Page
Loading...
