WAGNER TITANUS PRO-SENS - Connect the Fan at TITANUS PRO·SENS

TITANUS PRO·SENS
®
Installation
06/13
111
WARNING
Re-initialise the air flow if you change the ventilator voltage. Close or open
the jumper JU1 only when the device is switched off.
Connect the fan at TITANUS PRO·SENS
®
The electrical connection of the fan is made via terminal block X5 (FAN) on
the base board of TITANUS
PRO·SENS
®
:
▪ connect the red connecting lead of the fan with terminal block X5 / clip 1
(+)
▪ connect the black connecting lead of the fan with terminal block X7 / clip
2 (-)
NOTICE
When TITANUS PRO·SENS
®
is delivered, the fan is connected at the plant.
6.3.1.9