Installation
TITANUS
PRO·SENS
®
130
06/13
Data Log
The device can be tested with the diagnostic software DIAG 3. Besides the
current air flow sensor data, different status values can be read out, which
help the service technician to easily recognise modified operating conditions.
Air flow and smoke level values can be read out on site with a lap-top. After
the software has been started up, the data is read out on the PC via a USB-
Port. For details refer to the diagnostic software documentation. See also
chapter Commissioning “Operational Check”, using diagnostic software.
Figure 76: Connection of a PC via the connection diagnostic interface connection ca-
ble
TIP
For later checks of the device settings, save and archive the data after
commissioning.
6.9
To Next Page
Loading...
