WAGNER TITANUS PRO-SENS - Response Indicator - Electrical Connection

TITANUS PRO·SENS
®
Installation
06/13
129
Response indicator - electrical connection
Connect the response indicator via the terminal block X6 on the main board
in TITANUS
PRO·SENS
®
.
Note the permissible cable cross sections of the corresponding screw joints
and the permissible wire cross sections of the terminals (refer to chapter
"Technical Data").
Connect the response indicator to the current less TITANUS PRO ·S ENS
®
as
follows:
Figure 75: Connection of the response indicator at TITANUS PRO•SENS
®
6.8
Response indicato
r