WAGNER TITANUS PRO-SENS - 7.5 Monitoring in Forced Air Flow Systems

Installation pipe system
TITANUS PRO·SENS
®
142
06/13
Monitoring in forced air flow systems
(ventilation or climatic applications)
Detection at air inlets/outlets
NOTICE
If aspiration takes place in a forced air flow system (ventilator, climatic sys-
tems), the air sampling points must be positioned in the air flow. Place the
air sampling points as shown in following figure.
Figure 82: Positioning of air sampling point, depending on air speed
Detection in bypass systems
NOTICE
In case of detection with air flows ・ 2 m/s the outgoing air of the TITA-
NUS
®
is additionally to be returned to the air flow area. The end of the air
return pipe is to be cut in an elbow of 45° (see below).
For the air return connection please refer to chapter "Air Return".
7.5
7.5.1
7.5.2