Installation pipe system
TITANUS
PRO·SENS
®
134
06/13
WARNING
Adhesives and cleaning products contain solvents and are flammable. It is
essential to observe the supplier’s safety information before processing.
Glue the air sampling hose as follows:
Stick the air sampling hose by ABS glue into the hose bolting type SCH-PG-
16-VO. Turn the hose bolting into the specified pipe with female thread type
ABSR-2518-PG16.
Stick the air sampling hose by ABS glue into pipe fittings respectively
sleeves of a pipe system with 25 mm external diameter.
NOTICE
After pipe installation is complete, check for the following:
- air tightness (e.g. due to damage)
- any faulty connections
- correct projection of the aspiration aperture
NOTICE
The complete air sampling pipe must not consist solely of air sampling
hose.
NOTICE
Air flow reducers should not be applied to the air sampling hose.
Type SCH-PG16
Type SCH-P-25
To Next Page
Loading...
