WAGO Compact Controller 100 - TCP;IP Configuration Page; Table 66: WBM TCP;IP Configuration Page - TCP;IP Configuration Group

136 Appendix WAGO I/O System Compact
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
15.1.1.2.2 “TCP/IP Configuration” Page
The TCP/IP settings for the ETHERNET interfaces are shown on the “TCP/IP
configuration” page.
“TCP/IP Configuration” Group
The properties are displayed in a separate area for each configured bridge.
Table 66: WBM “TCP/IP Configuration” Page – “TCP/IP Configuration” Group
Parameter
Meaning
Network Details Bridge <n>
Settings for the bridge currently configured
Current IP Address
This displays the current IP address.
Current Subnet Mask
This displays current subnet mask.
IP Source
You can specify whether to use a static or dynamic
IP address.
Static IP
Static IP addressing
DHCP
Dynamic IP addressing via DHCP
BootP
Dynamic IP addressing via BootP
IP Address
Enter a static IP address. This is enabled if “Static
IP” is enabled in the
Configuration Type
field.
Subnet Mask
Enter the subnet mask. This is enabled if “Static IP”
is enabled in the Configuration Type field.
Click the [Submit] button to apply a change. The change takes effect
immediately.