WAGO Compact Controller 100 User Manual

160 Appendix WAGO I/O System Compact
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
15.1.1.2.14 “Configuration of NTP Client” Page
The settings for the NTP service are shown on the “Configuration of NTP Client”
page.
“NTP Client Configuration” Group
Table 93: WBM “Configuration of NTP Client” Page – “NTP Client Configuration” Group
Parameters
Explanation
Service enabled
Enable/disabled time update.
Update interval (sec)
Specify the update interval of the time server.
Time Server <n>
Enter here the IP addresses of up to 4 time servers.
Time server No. 1 is queried first. If no data is
accessible via this server, time server No. 2 is
queried, etc.
Additionally assigned
(DHCP)
The NTP servers assigned if necessary by DHCP
(or BootP) are displayed. If no NTP server has been
assigned by DHCP (or BootP), “(No additional
servers assigned)” is displayed.
To update the time regardless of interval, click the [Update Time] button.
Click the [Submit] button to apply the changes. The changes take effect
immediately.

WAGO Compact Controller 100 Specifications

General

Brand	WAGO
Model	Compact Controller 100
Category	I/O Systems
Language	English