WAGO Compact Controller 100 - Connectors; Network Connectors; Service Interface; Supply Voltage

WAGO I/O System Compact Properties 27
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
4.1.3 Connectors
4.1.3.1 Network Connectors
Table 5: Network Connections ETHERNET – “X1”, ”X2”
Contact
Signal
Description
1
TD +
Transmit Data +
2
TD −
Transmit Data −
3
RD +
Receive Data +
4
NC
Not assigned
5
NC
Not assigned
6
RD −
Receive Data −
7
NC
Not assigned
8
NC
Not assigned
4.1.3.2 Service Interface
The service interface „X3“ is used for the communication with WAGO Ethernet
Settings.
The USB service interface is designed as a USB-C socket. The interface
supports USB Specification 2.0.
The controller appears on the host device (PC) as a peripheral device in device
mode.
4.1.3.3 Supply voltage
Table 6: Supply Voltage – “X4”
Contact
Signal
Description
1
U
S
+
Supply voltage
2
GND
Ground
4.1.3.4 Digital inputs and outputs
The connectors are for connecting actuators and sensors.
picoMAX
®
plugs with push-in CAGE CLAMP
®
S connections are used.
4.1.3.4.1 Digital inputs
The controller receives binary control signals from digital field devices (e.g.,
sensors, encoders, switches or proximity switches).
The product has 8 input channels (8DI, 24 VDC, 2.8 mA).
Each input channel has a noise-rejection RC filter with a 5.0 µs time constant.