WAGO Compact Controller 100 - DHCP Server Configuration Page; Table 98: WBM DHCP Server Configuration Page - DHCP Configuration

164 Appendix WAGO I/O System Compact
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
15.1.1.2.17 “DHCP Server Configuration” Page
The “DHCP Server Configuration” page displays the DHCP service settings.
“DHCP Server Configuration Bridge <n>” Group
Table 98: WBM “DHCP Server Configuration” Page – “DHCP Configuration Bridge <n>” Group
Parameter
Explanation
Service active
Enable or disable the DHCP service for the interface
Xn.
Start IP for Range
Enter the start value of the available IP address
range.
End IP for Range
Enter the end value of the available IP address
range.
Lease time (min)
Specify the lease time here in seconds. 120 minutes
are entered by default.
Static Hosts
This displays the static assignments of MAC IDs to
IP addresses. If no assignment was defined, “No
static hosts configured” is displayed.
Add Static Host
You can add static MAC addresses or host names
and IP addresses.
MAC Address or Hostname
Enter a new static assignment, e.g.,
“01:02:03:04:05:06=192.168.1.20” or
“hostname=192.168.1.20”.
You can enter 10 assignments or host names.
Ip Address
Enter the IP address.
You can enter 10 IP addresses.
Click the [Submit] button to apply the changes. The changes take effect
immediately.
To accept a new assignment click the [Add] button. The change takes effect
immediately.
Click [Delete] to delete an existing assignment. The change takes effect
immediately.