WAGO Compact Controller 100 - Table 69: WBM Ethernet Configuration Page - Switch Configuration Group

WAGO I/O System Compact Appendix 139
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
“Switch Configuration” Group
This group only appears if parameter configuration is supported.
Table 69: WBM “Ethernet Configuration” Page – “Switch Configuration” Group
Parameters
Explanation
Port Mirror
Enable or disable mirroring of the data traffic
between the ports.
None
Both ETHERNET ports are operating
normally.
X1
The entire data traffic between X1 and
the PFC system is mirrored at port X2.
X2
The entire data traffic between X2 and
the PFC system is mirrored at port X1.
Fast Aging
Set here the aging time of unused entries in the list
of MAC addresses with a port assignment to
external network stations.
This field is only enabled in “switched” mode. Fast
aging is only effective in this mode.
Disabled
An unused address entry becomes
obsolete after 200 seconds.
Enabled
An unused address entry becomes
obsolete after 800 microseconds.
Broadcast Protection
You can set the broadcast limit for protection against
overloads.
Disabled
No broadcast packet limit
1 % … 5 %
Limits incoming broadcast packets to
the selected percentage of the total
possible data throughput (10/100 Mbit)
Rate Limit
You can set the basic limitation of the incoming data
traffic.
Disabled
No limitation of the incoming data traffic
64 kbps …
99 mbps
Limits the incoming data traffic to the
entered value
Click [Submit] to apply the change. The change takes effect immediately.