WAGO Compact Controller 100 - WBM User Configuration Page; Table 108: WBM WBM User Configuration Page - Change Password Group

176 Appendix WAGO I/O System Compact
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
15.1.1.2.24 “WBM User Configuration” Page
The settings for user administration are displayed on the “WBM User
Configuration” page.
“Change Password” Group
Changing Passwords
The initial passwords as delivered are documented in this manual and therefore
do not provide sufficient protection. Change the passwords to meet your
particular needs!
Table 108: WBM “WBM User Configuration” Page – “Change Password” Group
Parameter
Explanation
Old Password
Enter the current password here for authentication.
New Password
Enter the new password here for the user selected
under “Select User.”
Permitted characters for the password are the
following ASCII characters: a … z, A … Z, 0 … 9,
blank spaces and special characters:
! ? % + = ( ) _ # " - / ` < > * ; , : .
Confirm Password
Enter the new password again here for confirmation.
Click the [Submit] button to apply a change. The change takes effect
immediately.
Note the permitted characters for WBM passwords!
If passwords with invalid characters are set for the WBM outside the WBM (e.g.,
from a USB keyboard), access to the pages directly on the display is no longer
possible because only permitted characters are available from the virtual
keyboard.
General Rights of WBM Users
The WBM users “admin” and “user” have rights beyond the WBM to configure the
system and install software.
User administration for controller applications is configured and managed
separately.