WAGO Compact Controller 100 User Manual

WAGO I/O System Compact Appendix 175
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
Table 107: WBM “Configuration of SNMP v3” Page – “Actually configured v3 Users” Group
Parameters
Meaning
Authentication Type
Specify the authentication type for the SNMP v3
packets.
Possible values:
- Use no authentication (“None”)
- Message Digest 5 (“MD5”)
- Secure Hash Algorithm (“SHA”)
Authentication Key (min. 8
char.)
Specify the authentication key. The key must be
min. 8 and max. 32 characters long and contain
lower case letters (a … z), upper case letters
(A … Z), numbers (0 … 9), special characters !()*~'.-
_ but no spaces.
Privacy
Specify the encryption algorithm for the SNMP
message.
Possible values:
- No encryption (“None”)
- Data Encryption Standard (“DES”)
- Advanced Encryption Standard (“AES”)
Privacy Key (min. 8 char.)
Enter the key for encryption of the SNMP message.
If nothing is specified here, the “authentication key”
is automatically used. The key must be min. 8 and
max. 32 characters long and contain lower case
letters (a … z), upper case letters (A … Z), numbers
(0 … 9), special characters !()*~'.-_ but no spaces.
Notification Receiver IP
Specify an IP address for a trap receiver for v3
traps. If no v3 traps are to be sent for this user, this
field remains blank.
Click the respective [Delete] button to delete an existing user.
Click [Add] to add a new user.
The changes only take effect after the controller restarts. For this purpose, use
the WBM reboot function. Do not shut down the controller too early!

WAGO Compact Controller 100 Specifications

General

Brand	WAGO
Model	Compact Controller 100
Category	I/O Systems
Language	English