WAGO Compact Controller 100 - Operating Elements; Operating Mode Switch; Reset Button; Table 17: Mode Selector Switch

34 Properties WAGO I/O System Compact
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
4.1.5 Operating Elements
4.1.5.1 Operating Mode Switch
</dg_
Table 17: Mode Selector Switch
Position
Actuation
Function
RUN Latching
Normal operation
e!RUNTIME applications running.
STOP Latching
Stop
All e!RUNTIME applications have stopped.
RESET Spring-return
Reset warm start or
Reset cold start
(depending on length of actuation, see Section
“Starting” > “Initiating Reset Functions”)
</dg_
Other functions can also be initiated using the reset button.
4.1.5.2 Reset Button
The Reset button is installed behind drilling to prevent operating errors. It is a
shortstroke button with a low actuating force of 1.1 N … 2.1 N (110 gf … 210 gf).
The button can be actuated using a suitable object (e.g., pen).
You can initiate different functions using the Reset button depending on the
position of the mode selector:
• Temporarily set a fixed IP address (“Fixed IP Address” mode, see section
“Commissioning” > “Setting an IP Address” > “Temporarily Setting a Fixed
IP Address”)
• Perform a software reset (restart, see section “Commissioning” > “Initiating
Reset Functions” > “Software Reset”)
• Restore factory setting (factory reset, see section “Service” > “Firmware
Changes” > “Factory Reset”)