WAGO Compact Controller 100 - Configuration of General SNMP Parameters Page; Table 104: WBM Configuration of General SNMP Parameters Page - General

WAGO I/O System Compact Appendix 171
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
15.1.1.2.21 “Configuration of General SNMP Parameters” Page
The general settings for SNMP are given on the “Configuration of General SNMP
Parameters” page.
“General SNMP Configuration” Group
Table 104: WBM “Configuration of General SNMP Parameters” Page – “General SNMP
Configuration” Group
Parameter
Explanation
Service active
Activate/deactivate the SNMP service.
Name of device
Enter here the device name (sysName).
Description
Enter here the device description (sysDescription).
Physical location
Enter here the location of the device (sysLocation).
Contact
Enter here the email contact address (sysContact).
Object ID
Enter here the object ID (sysOID).
Click the [Submit] button to apply the changes. The changes only take effect
after restarting the controller. For this purpose, use the WBM reboot function. Do
not shut down the controller too early!