WAGO Compact Controller 100 - Table 117: WBM Configuration of MAC Address Filter Page - MAC Address Filter State Bridge <N> Group; Table 118: WBM Configuration of MAC Address Filter Page - MAC Address

184 Appendix WAGO I/O System Compact
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
“MAC address filter state Bridge <n>” Group
A separate group is displayed for each configured bridge.
Table 117: WBM “Configuration of MAC Address Filter” Page – “MAC address filter state Bridge <n>”
Group
Parameter
Explanation
Filter enabled
Enable or disable here the MAC address filter for the
specific bridge.
Click the [Submit] button to apply the change. The change takes effect
immediately.
“MAC address filter whitelist” Group
Each list entry has its own area in the display.
Table 118: WBM “Configuration of MAC Address Filter” Page – “MAC address filter whitelist” Group
Parameters
Explanation
MAC address
Displays the MAC address of the relevant list entry.
MAC mask
This displays the MAC mask of the relevant list
entry.
Filter enabled
Enable or disable the filter for the relevant list entry.
Add filter to whitelist
Create a new list entry.
MAC address
Enter here the MAC address for a new list entry.
You can enter 10 filters.
MAC mask
Enter the MAC mask for the new list entry.
Filter enabled
Enable or disable the filter for the new list entry.
Click the [Submit] button to apply the change. The change takes effect
immediately.
Click the appropriate [Delete] button to remove an existing list entry. The change
takes effect immediately.
Click [Add] to accept a new list entry. You can enter 10 filters. The change takes
effect immediately.