WAGO Compact Controller 100 - Table 7: Digital Inputs - X12; Digital Outputs

28 Properties WAGO I/O System Compact
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
The inputs provide high-side switching. If the 24V potential for field power Uout+
(“X12” connector) is switched to an input connection, the signal status for the
corresponding input channel is set to “high”.
A green status LED for each channel indicates the signal status.
The meaning of the LEDs is described in Section “Display Elements” > “LEDs
Status DI/DO”.
Table 7: Digital inputs – “X12”
Contact
Signal
Description
1
U
out
+
Supply voltage output (DI1 … DI8)
2
GND
Ground
3
DI1
Digital input 1
4
DI2
Digital input 2
5
DI3
Digital input 3
6
DI4
Digital input 4
7
DI5
Digital input 5
8
DI6
Digital input 6
9
DI7
Digital input 7
10
DI8
Digital input 8
4.1.3.4.2 Digital outputs
The controller transmits binary control signals from an automation device to
connected actuators (e.g., magnetic valves, contactors, transmitters, relays or
other electrical loads).
The product has 4 output channels (4DO, 24 VDC, 0.5 A).
The outputs provide high-side switching. If the signal status of an output channel
is at “high”, the 24V potential for field power is switched to the appropriate output
channel.
A green status LED for each channel indicates the signal status.
The meaning of the LEDs is described in Section “Display Elements” > “LEDs
Status DI/DO”.
The field level is electrically isolated from the system level.
The connections are specified per EN 61010-2-201:
DC, general use