WAGO Compact Controller 100 - Table 84: WBM Active System Page - System <N> (Internal Flash) Group; Table 83: WBM Active System Page - Boot Device Group; Active System Page

WAGO I/O System Compact Appendix 155
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
15.1.1.2.10 “Active System” Page
The settings for specifying the partition from which the system is started are
shown on the “Active System” page.
“Boot Device” Group
Table 83: WBM “Active System” Page – “Boot Device” Group
Parameter
Explanation
Boot Device
The storage medium from which the device was
booted is displayed here.
“System <n> (Internal Flash)” Groups
Table 84: WBM “Active System” Page – “System <n> (Internal Flash)” Group
Parameter
Explanation
Active
This shows whether the system is active.
Configured
This shows whether the system should be active
after the next reboot.
State
The system status is displayed here.
good
The system is valid and can be used.
bad
The system is not valid and cannot be
used.
Click the respective [Activate] button to start the required system at the next
reboot.
Provide a bootable system!
A functional firmware backup must be available on the boot system!