Replacing the lamp 4-21
Removing the lamp
Installing the new lamp
Before you begin:
1. Unpack the lamp from its packing material. The new lamp may vary
slightly from the lamp illustrated in the figure above.
2. Inspect the new lamp for particles or dirt. If necessary, clean the lamp
with a gas duster or lens tissue.
Warning: To avoid the possibility of exposing your eyes to ultraviolet
radiation, never ignite a lamp while it is outside the instrument or if
it is not properly screwed in place.
Caution: Do not touch the glass bulb on the new lamp. Dirt or
fingerprints on the bulb affect detector operation. If the lamp needs
cleaning, gently clean the bulb with ethanol and lens tissue. Do not
use any abrasive tissue or apply excessive pressure.
TP0281
To Next Page
Loading...
