Waters 2489 - Connecting to Other Devices

2-20 Installing the Detector
Separations module connections to the detector for Chart Mark on Inject
Connecting to other devices
You can connect the detector to a wide range of HPLC system devices. This
section describes how to connect the detector to the following devices:
• e-SAT/IN™ module (instead of Ethernet)
• Waters 745/745B/746 Data Module
• Chart recorder
• Waters 600 Series Pump
• Waters 717plus Autosampler
• Waters fraction collector
For details on connecting to other data modules, see the operator’s guide for
the module you are using.
TP01526
Waters 2695 Separations Module
B
Waters 2489
II