Weber Packaging Solutions, Inc.
5
Product Detector Setup
This chapter covers the setup and adjustment procedures for the product
detector. It explains how to position the applicator and adjust its
sensitivity.
Positioning the Applicator
The applicator needs to be in a position to properly apply a label to the product. Make sure that all the
moving parts have enough clearance to avoid any obstacles in the area.
The product must be repeatedly fed into the applicator in order to attain label placement accuracy.
Product Detector Sensitivity Setup
Mount the product detector and its reflector (if applicable) before adjusting the product detector
sensitivity. The detector may need to be repositioned when actual products are being labeled. Refer to
the instructions included in the product detector packaging.
To Next Page
Loading...
Need help?
General
