Chapter 6
6-4 Printer-Applicator User’s Manual
Setup Menu
The Setup Menu allows the operator to set the parameters for the following applicator functions:
Set Options, Active Edge Mode, Set Run Mode and Set Timers. See the following sections for
menu and function information.
Set Options
Trigger Count
The number of product detector events that must occur per label application event.
The factory default value is 1.
LOP Sensor
LOP (label-on-pad) is an optional sensor that is available to detect the presence of a
label on the tamp pad. If enabled, the controller checks for a label on the pad after a
print cycle and issues a general error if the label is not present.
The factory default value is OFF.
Tamp Error
When enabled, the applicator issues an error when the tamp assembly moved off the
home position without instruction from the control system.
The factory default value is OFF.
Factory Setup
Returns all parameters to the factory set defaults.
Run At Start Mode
When enabled the machine enters RUN mode after the power is applied. When disabled
the machine enters IDLE mode after the power is applied.
The factory default value is ON.
Vacuum Shut-Off
The Vacuum Shut-off feature turns off vacuum when it is not needed to conserve
compressed air resources. Vacuum is applied automatically at the start of label printing.
This is an optional feature that requires an additional pneumatic solenoid valve.
The factory default value is OFF.
VT Air Blast Only
When enabled and an optional Variable Tamp (VT) Sensor is installed, tripping the VT
Sensor issues an Air Blast event but does not retract the tamp. The tamp continues to
extend until the TAMP Extend time expires.
The factory default value is OFF.
To Next Page
Loading...
Need help?
General
