Chapter 3
3-4 Printer-Applicator User’s Manual
Moving and Transporting the Printer-Applicator
The T-base is designed only to provide roll-away access from the adjacent labeling area for
applicator service. Take care when moving the machine to prevent tipping.
! CAUTION ! Cracks and bumps in the floor may cause a caster to suddenly
stop or change direction.
To move the printer-applicator:
1. Return the applicator to an “upright and above” orientation on the T-base stand. Rotate
the printer-applicator about one axis at a time to achieve this.
2. Lower the applicator to the bottom of travel on the T-base vertical carriage.
To transport the printer-applicator:
If the applicator needs to be transported over a greater distance, additional safety measures must
be followed.
1. Remove the printer-applicator from the T-base.
2. Properly repack the equipment for shipping.
To Next Page
Loading...
