Maintenance
Weber Packaging Solutions, Inc. 7-3
Six-month Maintenance
1. Replace the air filter elements and clean the filter bowl in the filter regulator.
NOTE: Do not use air pressure from the shop air supply to blow dust from the
machine. There is a possibility that this air can contain water and emulsified oil,
which can damage the electrical components in your machine.
2. Clean the inside and outside of the machine enclosure using an industrial vacuum
cleaner.
3. Check the tamp home sensor adjustment. (Refer to Tamp Home Sensor Adjustment.)
4. Check tension of unwind and rewind dancer arms. Adjust if loose.
5. Check urethane stop collars on tamp assembly. Replace if worn.
6. Check pneumatic tubing for cracks or wear. Replace if worn.
To Next Page
Loading...
