WEG SSW-06 - Page 131

CHAPTER 6 - DETAILED PARAMETER DESCRIPTION
131
Range
[Factory Setting]
Parameter Unit Description / Notes
Figure 6.25 - Operation via keypad and .
Figure 6.26 - Operation via three-wire digital inputs (DI1 and DI2)
Un
P104=0
P630=10s
Un
P104=6s
t
t
P630=10s
Un
P104=0
P630=10s
t
t
Un
P104=6s
P630=10s
P630=10s
 This function limits the minimum time interval to a new start after
themotorhasbeenswitchedO󰀨.
NOTE!
The behavior of this function has changed, if compared to the
software versions that preceded the V1.40. Now the time interval
starts after power is removed from the motor.
P630 2 to 999
Interval of Time [ 2 ]
After Stop 2s
deactivated by the error output.