CHAPTER 2 - GENERAL INFORMATION
30
2.5 RECEIVING AND
STORAGE
The SSW-06 is supplied in packaging according to the model:
- Models 10A to 205A in a cardboard box;
- Models 255A to 365A in a cardboard box over a wooden box;
- Models 412A to 1400A in a wooden box.
The outside of the packing container has a nameplate that is identical
to that on the Soft-Starter SSW-06. Please check if the nameplate
data matches the ordered data.
The models up to 205A must be placed and opened on a table with the
help of two or more people, open the box, remove the foam protection
and remove Soft-Starter SSW-06.
Modelsgreaterthan255Amustbeopenedontheoor.Openthebox
and, remove the bolts that fasten the Soft-Starter SSW-06 on the pallet.
The Soft-Starter SSW-06 must be handled with a hoist.
Check if:
The Soft-Starter SSW-06 nameplate data matches the purchase
order;
The equipment has not been damaged during transportation. If
any problem is detected, contact the carrier immediately.
If the Soft-Starter SSW-06 is not to be installed immediately, store it
within its original cardboard box in a clean and dry room (Storage
temperatures between -25°C (-13°F) and 65°C (149ºF)).
To Next Page
Loading...
Need help?
General
