Live organ – Live Accordion – Church Organ
54 Operating Manual
Rotor fast / slow
Here you can choose whether you can use the Rotor Slow / Fast control panel button to switch only the
rotor, only the vibrato or both rotor and vibrato together between fast and slow.
Information: With the older WERSI instruments such as SPECTRA, DELTA or HELIOS there was no rotor
simulation, but the WERSI VOICE. In addition to the normal fast vibrato speed (Fast), there was also a slow
speed (Slow) for vibrato. And as with a rotor, the WERSI VOICE (vibrato) could also be switched between
slow and fast with a slow / fast control panel button.
Volume of the percussion
Select the desired volume here from the levels soft, standard and loud.
Key click variations
Here you can choose between four different clicks.
Attack and sustain settings
You can switch on attack, release or both using the display buttons Attack and Release under ENVELOPE.
How long the attack or the release is can be set here in three stages.
Attack length: With the function Attack you can make the start of the notes smoother. With Standard the
sound starts immediately. With medium and long two settings are available which let the sound swing in
more gently.
Sustain Length: With the Sustain function you can lengthen the decay of the notes. With standard, the sound
ends immediately after releasing the key. With medium and long two settings are available that let the sound
fade away longer.
Setting FREE
Free On
If you save your own drawbar sound, you can activate the FREE function before saving. Free means that
when registering this drawbar tone, the current panel button and footage values will be used.
Free Off
If you save the sound with FREE not activated, the sound will be saved completely. So with the settings of the
9 footages and the settings on the control panel.
To Next Page
Loading...
Need help?
General
