OAX-System 35
4.6.3.4 Fast operation Chorus
Once you have briefly tapped the Chorus button, the display will appear to set the Chorus effect.
For the MANUALS, ACCOMPANIMENT and DRUM
areas, you will find a controller with which you can
adjust the output of the chorus effect device, also
called RETURNS.
Small tip: As long as no sound is selected that also
uses a chorus, there may be no change to be
heard. To set the chorus effect per sound, see the
chapter for EASY mode for easy mode 7.2 „The
EASY Manual Controller“ or PROFI mode in
chapter 8.4.1 „The Standard Control“.
If you do not make any settings, the display will
disappear after a few seconds. When the HOLD
display button is pressed, the display remains
permanently displayed.
You can use the appropriate slider to vary the
volume of the chorus effect. With RESET, you reset
the volume to the value stored in the Effects
program.
To change the Chorus program, briefly tap the
appropriate name field. Here in the example on
"Chorus 3" in the manuals section.
The selection box of possible chorus programs
opens. Once you have programmed your own
effect settings and given a name, these effect
presets will also appear in this list.
After you select a new program, the window
closes and the newly selected chorus program is
active.
If you don't make a selection, the window will
automatically close after a few seconds.
Note: You can find out how to program your own
effects in the chapter 8.11 Effects.
To Next Page
Loading...
Need help?
General
