Live organ – Live Accordion – Church Organ
62 Operating Manual
Volume Switch Noise
Some rocker switches of the FARFISA Compact produce a slight crackling noise when used. You can set this
noise to quiet or loud or switch it off completely.
Effects
The effects can be switched on and off using the five large display buttons. These display buttons are
identical to the 5 effect buttons on the first page.
CHORUS
Balance between the original sound and the chorus
DELAY
Controls the volume of the echoes
Echo Velocity (spacing of echoes)
Feedback of the generated echo signal. If this parameter is set to zero, only
an echo is generated.
Splits the echo into two parts and shifts them from left to right or vice versa.
The longer the echo, the duller the sound becomes.
SCANNER (Vibrato)
Here the typical modes C1, C2, C3 and V1, V2 and V3 of a scanner vibrato can
be adjusted.
Speed of the scanner vibrato
Intensity of the vibrato. When the slider is at zero, there is no scanner
vibrato.
Makes the scanner function rougher.
Amplification of the amplitude modulation
Rotor
Controls the proportion between the original sound without the rotor and
the sound produced by the rotor.
Controls the crossover frequency between the bass and horn components.
Controls the stereo width
Controls the speed of the bass drum
Controls the speed of the horn
AMP (Verstärker)
Adjusts the ratio between the original unamplified sound and the amplified
sound
Choice of AC, Vintage, 2x2, 4x12, Axis, Dark 1, Dark 2 and Radio amp types
Intensity of the distortion
Feedback of the distorted signal
Switching between stereo and mono