Xerox 4595 Copier/Printer User Guide
3-25
3. Scan
Scan to FTP/SMB
You can convert scanned data to TIFF, DocuWorks, or PDF
formats, and then use the FTP or SMB protocols to send the data
to a computer on the network. For information about initializing
data, refer to below.
NOTE: A shared folder saving scanned documents by computer
side needs to be made before scanning the document. You also
need to configure the FTP service when using FTP protocol
transmission. For information about how to setup from computer
side, refer to the manual provided with the computer operating
systems For information about setup for the machine, consult
"Scan to FTP/SMB Defaults" in the System Administration Guide.
An optional package is necessary for this selection. For
more information, contact the Customer Support Center.
What follows is the basic procedure to scan to FTP/SMB.
1. From the All Services screen, select Scan to FTP/SMB.
NOTE 1:If the All Services screen is not shown, press the All
Services button.
NOTE 2:Fields displayed vary depending on the selected
protocol.
NOTE 3:If you have the optional Color Scanner Kit installed, the
bottom section of the screen will be different than the one shown
above.
2. Specify a Transfer Protocol.
3. Specify a Forward destination from the Basic Scanning
screen.
Transfer Protocol
Select Transfer Protocol, and in the next screen, select FTP,
SMB, or SMB (UNC Format) as a forwarding protocol. For
information about each protocol, refer to “Specify a Forwarding
Destination” on page 3-27.
To Next Page
Loading...
Need help?
General