Xerox 4595 User Manual

Xerox 4595 Copier/Printer User Guide
11-4
11. Problem Solving
Online indicator
does not light
even though you
instructed it to
print.
Is the interface cable
disconnected?
Turn the power switch off, unplug the
power cord from the power outlet, and
check the interface cable connection.
For information about network settings,
refer to the System Administration Guide.
Is the environment correctly
set on the personal
computer?
Check the print driver and other
environment settings on the personal
computer.
Is the required interface
set?
Check the status of the interface port in
use.
For information about network settings,
refer to the System Administration Guide.
Printing is not
performed even
though printing
was instructed
on Tray 5
(Bypass).
Is paper of the size
specified for printing loaded
on the tray?
Follow the instructions displayed to load
paper of correct size and instruct it to print
again.
Refer to “Load paper in Tray 5 (Bypass)”
on page 7-6.
Unsatisfactory
print quality.
A probable cause is an
image defect.
Remedy the trouble referring to Image
Quality Trouble described later.
Refer to “Image Quality Problems” on
page 11-9.
Text is not
printed correctly
(text is
corrupted).
Non-standard fonts are
used for printing.
Check the application or print driver
settings.
Online indicator
lights and copies
are not delivered
with Online still
lit.
Data remaining in machine
memory.
Cancel printing, or purge remaining data.
Refer to “Checking Current/Pending Jobs”
on page 8-2.
Cannot open or
close trays.
Did you open a cover or turn
power off during printing?
Turn the power off without unnecessarily
closing or opening a paper tray. Wait
several seconds and then turn the power
switch on. Make sure that the machine is
online (ready to receive data) and then
close or open the paper tray.
Symptoms Check Remedy

Xerox 4595 Specifications

General

Brand	Xerox
Model	4595
Category	Copier
Language	English