Xerox 4595 - Page 407

Xerox 4595 Copier/Printer User Guide
11-45
11. Problem Solving
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
116-790
 Cause There was a problem with parameters in the JBIG data.
They were automatically edited.
Remedy If any problem occurs in job result, try to process the job
again.
116-780 Cause There is a problem with the document attached to the
received mail.
Remedy Check the attached document.
123-400  Cause A malfunction occurred in the machine.
Remedy Power-cycle the machine. If the machine error is not
fixed by performing the relevant remedy, contact the
Customer Support Center.
127-210 Cause Communication error between the printer and the
controller. Error detected by the printer.
Remedy Remove and reinsert the cable connection between the
printer and the controller. Power off and on both the
printer and the controller. If the problem persists, call the
Customer Support Center.
127-211 Cause Detected a communication error between the printer and
the controller.
Remedy Remove and reinsert the cable connection between the
printer and the controller. Power off and on both the
printer and the controller. If the problem persists, call the
Customer Support Center.
127-212 Cause Detected an internal print check error by the controller.
Remedy Remove and reinsert the command/video cable between
the controller and the printer. Power off and on both the
printer and the controller. If the problem persists, call the
Customer Support Center.
127-213 Cause Detected a mismatch with the software version of the
controller.
Remedy Contact the Customer Support Center for information
and/or instructions to remedy the problem.
127-220 Cause Detected a communication error of the video system by
the controller.
Remedy Remove and reinsert the cable connection between the
printer and the controller. Power off and on both the
printer and the controller. If the problem persists, call the
Customer Support Center
127-221 Cause Detected a communication error by the controller.
Remedy Remove and reinsert the cable connection between the
printer and the controller. Power off and on both the
printer and the controller. If the problem persists, call the
Customer Support Center.
Error Code
Category
Cause and Remedy
CPSMO